111S08080091L34 Product Features
* Incorporates a PATENTED CONDUCTIVE NEXT Reduction System. In addition to providing PRECISE CONDUCTOR ALIGNMENT, the Composite Carbon/Graphite Fiber Conductor Load Bar GREATLY REDUCES NEXT and RETURN LOSS by ABSORBING REFLECTIONS and CHANNELING IT AWAY FROM THE CONDUCTORS. Using recommended termination procedures and equipment, ANSI/TIA 568.2-D Category 6 performance levels are achievable with good workmanship and certified cables.
* Utilizes a 4 over 4 contact design (4 LONG and 4 SHORT) that provides increased isolation and spatial dispersion within the plug to minimize crosstalk and accepts .048″ – 0525″ INSULATED CONDUCTOR OD.
* The conductors are isolated by the Conductor Load Bar and through Plastic Isolation/Insulation Barriers where contact termination is made, thereby improving electrical performance.
* Plug accepts both SOLID or STRANDED conductors
* Made in USA
Performance: Meets or Exceeds ANSI/TIA 568.2-D – ANSI/TIA 1096 (Formerly FCC Part 68) – ANSI/TIA 968-A – CENELEC EN 50173 – IEC 60603 – ISO-8877 – ISO/IEC 11801
Contact Material: Phosphor Bronze – .012″ thick
Contact Plating: Minimum 50 Micro-Inch Pure Gold – Selective 24 Carat Hard Gold Plate in contact area over 100 Micro-Inch minimum Nickel Plate. Exceeds TIA-1096 specifications (formerly FCC Part 68)
Plug Material: Polycarbonate
Plug Tolerances and Dimensions: Meets TIA-1096 specifications (formerly FCC Part 68)
UL Recognized: UL File #E188111 – UL 1863 (1000v)
Flame Autoextinguish: 94V-0
Operating Temperature: -40º C to +85º C
Insertion/Extraction Life: 1000 Minimum Cycles
Contact Resistance: 10 Milli-Ohms maximum
Current/Voltage: 30 VAC/57 VDC at 1.5 Amps
Compliance: RoHS Compliant
PoE: Meets requirements of 15W PoE (IEEE 802.3af), 30W PoE+ (IEEE 802.3at), 60W PoE++ (IEEE 802.3bt Type 3) and 100W PoE++ (IEEE 802.3bt Type 4)
COMPLEMENTARY PRODUCTS TO “DO THE JOB RIGHT”
Cable assemblies built using inadequate or poor quality tools and dies….. worn out tooling….. or mismatched tooling, WILL HAVE A MAJOR IMPACT ON THE PERFORMANCE OF THE CABLE ASSEMBLY.
PROPER CABLE PREPARATION INCLUDES COPPER SHIELDING TAPE TO MAINTAIN SHIELD INTEGRITY & PROVIDING A PLACE FOR THE “C CRIMP” SHIELD ON THE CABLE3M™ 1181
1/2″ Copper Foil Shielding Tapewith Conductive Adhesive
SNAGLESS STRAIN RELIEF BOOT OPTIONS
8MM SNAGLESS BOOT
Accepts up to 8MM Jacket OD (.314″)
Care must be taken to fully wrap the C CRIMP around the Cable (360º) to insure proper fit.
3M™ HEAT SHRINK TUBING
1/2 Inch Diameter
1-99, 100-999, 1000
The RJ-45 Is A Highly Engineered Interconnection System
CAVEAT EMPTOR.....Let The Buyer Beware
SUB-STANDARD, NON-COMPLIANT and COUNTERFEIT RJ45's coming in from the Far East
KNOW THE STANDARDS - KNOW THE SPECS - INSIST ON COMPLIANCE - KNOW YOUR SUPPLIERS